When there is no overlap (Evoral::OverlapNone) of local transport
position and the record-range, MIDI data does not need to be
offset.
This matches audio recording: Only write to the capture ringbuffer
when there is an overlap.
(There is still some unknown, unresolved discrepancy remaining
to be tracked down)
to_write must not exceed `total = _samples_pending_write`.
If the write succeeds (events spanning `to_write` samples are written)
to_write is atomically subtracted from `_samples_pending_write`.
This produces synchronous events on Audio and MIDI ports.
One rvent per second, exactly at every second since engine-start.
MIDI: C-4 Note-on/off (1 sample long)
Audio: +1/-1 transition:
+1 in sync with Note-on,
-1 in sync with Note-off
the value is used by the parser context; the old code called it only after the *first* parser context
was created. therefore the first XMLTree::read() call has its behavior determined by libxml2's default
for this value, rather than by our explicit choice (do not treat whitespace as a note). All subequent
read() calls will use our value.
This variable inside libxml2 is actually per-thread, which just increases the stakes for calling
xmlKeepBlanksDefault() at the right time
Some builds of glib on macOS end up delivering IO_PRI when IO_IN is also set. This differs from our own build stack
version, but it isn't really an error, so we should handle it.
This partially reverts 2edbda2526.
Using cairo-groups increases performance on MacOS, and retains
retina-resolution.
However it adds a performance regression for MS Windows graphics
rendering. cairo-groups use a "similar" surface, not an image surface.
Empirically this adds significant overhead compared to rendering
using the CPU and using bitblt.
This reverts commit af30a6f001
because it breaks OSX/MacOS builds:
libs/surfaces/mackie/mackie_control_protocol.cc:945: error: 'G_SOURCE_FUNC' was not declared in this scope
Session::TransportStateChanged notifies about transport stop before the stop is complete (i.e. at the start of the declick).
Various other objects (notably control surfaces) connect to this signal and use it to modify their displayed state.
We need a method that can tell them we are stopped (or stopping) even though we are not "fully" stopped yet. This is
that method
This is similar to sort(1) --human-numeric-sort,
as opposed to naturally_less() negative numbers, hex-prefixes
and SI metric prefixes are taken into account.
